ITER collective Thomson scattering-Preparing to diagnose fusion-born alpha particles (invited).

The ITER Collective Thomson scattering (CTS) diagnostic will measure the dynamics of fusion-born alpha particles in the burning ITER plasma by scattering a 1 MW 60 GHz gyrotron beam off fast-ion induced fluctuations in the plasma. The diagnostic will have seven measurement volumes across the ITER cross section and will resolve the alpha particle energies in the range from 300 keV to 3.5 MeV; importantly, the CTS diagnostic is the only diagnostic capable of measuring confined alpha particles for energies below ∼1.7 MeV and will also be sensitive to the other fast-ion populations. The temporal resolution is 100 ms, allowing the capture of dynamics on that timescale, and the typical spatial resolution is 10-50 cm. The development and design of the in-vessel and primary parts of the CTS diagnostic has been completed. This marks the beginning of a new phase of preparation to maximize the scientific benefit of the diagnostic, e.g., by investigating the capability to contribute to the determination of the fuel-ion ratio and the bulk ion temperature as well as integrating data analysis with other fast-ion and bulk-ion diagnostics.

Fast production of microwave component prototypes by additive manufacturing and copper coating.

We present a novel method for efficient production of prototypes of microwave components by fused depositing modeling, also known as 3D plastic printing, and vapor deposition coating of a 1 µm copper layer. We demonstrate that the properties of the components follow the predicted performance for low power microwave propagation. The production method offers new opportunities for cheap and efficient production of mock-ups and prototypes of advanced-geometry components for tests with low-power microwaves.

Waste collection systems for recyclables: an environmental and economic assessment for the municipality of Aarhus (Denmark).

Recycling of paper and glass from household waste is an integrated part of waste management in Denmark, however, increased recycling is a legislative target. The questions are: how much more can the recycling rate be increased through improvements of collection schemes when organisational and technical limitations are respected, and what will the environmental and economic consequences be? This was investigated in a case study of a municipal waste management system. Five scenarios with alternative collection systems for recyclables (paper, glass, metal and plastic packaging) were assessed by means of a life cycle assessment and an assessment of the municipality's costs. Kerbside collection would provide the highest recycling rate, 31% compared to 25% in the baseline scenario, but bring schemes with drop-off containers would also be a reasonable solution. Collection of recyclables at recycling centres was not recommendable because the recycling rate would decrease to 20%. In general, the results showed that enhancing recycling and avoiding incineration was recommendable because the environmental performance was improved in several impact categories. The municipal costs for collection and treatment of waste were reduced with increasing recycling, mainly because the high cost for incineration was avoided. However, solutions for mitigation of air pollution caused by increased collection and transport should be sought.